• Along side a fence
• Against house wall (only 260mm wide)
• To form an internal courtyard
• To screen off the back yard
• AUSTRALIAN MADE

Provides minimum intrusion on your property. Use any number of tanks to achieve the desired capacity.

Ask about Government rebates.

Against a wall:

1. Select preferred location for the tank
2. Ensure base is solid and level e.g. Concrete,pavers or compressed dolomite (surface must be of same material the total foot of the tank)
3. Place tank against the wall
4. Position the z-bracket against the wall and tank approx. 300mm down from the top of the tank
5. Mark and drill three holes (8-10 mm) in the 50mm section of the bracket
6. Reposition the z-bracket against the wall and tank
7. Mark and drill the wall
8. Insert three dynabolts, reposition the tank and tighten the dynabolts
9. Repeat this procedure for the opposite end of the tank

Wall must be brick or like and must be solid. If the wall is brick or like, but not solid, a chemical anchor is recommended.

Free standing:

1. Position tank into preferred location
2. Ensure base is solid and level e.g. Concrete, pavers, or timber sleeper (surface must be of same material the total foot of the tank)
3. Mark position of 65mm x 65mm posts
4. Remove tank or tanks and dig a hole 250mm dia. A minimum of 600mm deep for each post
5. Reposition tank into preferred location
6. Position posts, check alignment and concrete posts

FEATURES

1. Manufactured from 100% U.V. stabilised, food grade polyethylene resin
2. To ensure maximum strength, all Thintanks are made of a solid one piece construction
3. Tanks are fitted with 2 brass 20mm outlets at the bottom to allow joining of tanks together an ease